SOCATA TB20GT, Pilot'S Information Manual

Page: 65 / 213

SECTION 4
NORMAL PROCEDURES
SOCATA
MODEL TB 20
The content of this document is the property of
socata
. It is supplied in
confidence and commercial security of its contents must be maintained.
It must not be used for any purpose other than that for which it is supplied, nor
may information contained in it be disclosed to unauthorized persons. It must not
be reproduced nor transmitted in any form in whole or in part without permission
in writing from the owners of the Copyright.
Information in this document is subject to change without notice.
© 1988, 1991, 1992, 1994 to 1996, 1997, 2000 -
socata
- All rights reserved
Back to
Contents
June 30, 1988
Revision 8
4.9
d – Airplane rear part
Navigation light (Pre–MOD.151) Illuminated
Strobe light (if installed) Flashing
Anticollision light (if installed) Flashing
e – Cabin
Navigation lights OFF
Strobe lights (if installed) OFF
Anticollision lights (if installed) OFF
Recognition lights
(if installed) (Post–MOD.151)
OFF
Pitot heating (if installed) OFF
Landing and taxi lights OFF
Instrument lights OFF
Main switch OFF
BEFORE STARTING ENGINE
Preflight inspection Carried out
Doors CLOSED, check catches in place
Main switch OFF
Parking brake Set
Parking brake light ”PARK” Illuminated
Seats, seat belts,
shoulder harnesses
ADJUSTED and SECURE
Flight controls Check for proper operation
Pitch trim Check deflection
Rudder trim Check deflection
Fuel selector OPEN (L.H. or R.H.)
Circuit breakers (side panel) Closed
Magneto selector OFF
Emergency landing gear control PUSHED
”Radio master” (if installed) OFF
Landing gear lever DOWN
”Alternate Air” PUSHED
Alternate static source
(if installed)
PUSHED
Air conditioning (if installed) OFF