SnowWolf AlphaBlower 33-100-H, Operation & Maintenance Manual

Page: 26 / 98

24
AlphaBlower Operation and Maintenance Manual
Operation
Tractor Requirements
PTO Revolutions
NOTE: It is important to use the correct type of
PTO shaft! The PTO shaft for towing
and reversing is adapted for 540 rpm
and must NOT be used for front
mounting as this could result in the
gearbox becoming overloaded. For
front loading a PTO shaft with a shear
pin adapted for 1000 rpm must be used.
Loader Requirements
Entering and Exiting the
Machine
Entering The Operator’s Position
Use the machine’s safety treads, handles and
steps to enter the operator’s position.
When in the operator’s position, fasten the seat
belt, start the engine and release the parking
brake.
Exiting The Operator’s Position
AVOID SERIOUS INJURY OR DEATH
Before servicing the snow blower:
• Always park on a flat level surface.
• Lower the tractor’s three-point hitch or
loader arms and place snow blower flat
on the ground.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Stop the engine and remove the key.
• Wait for all moving parts to stop.
• Exit the machine.
SEE MACHINE’S OPERATOR’S MANUAL
FOR ADDITIONAL INFORMATION.
Park the machine and snow blower on a flat level
surface.
Place all controls in neutral, engage the park
brake, stop the engine and wait for all moving
parts to stop. Leave the operator’s position.
REQUIREMENTS
Power Input (min/max) 130 - 250 HP
Hitch Type Cat 2, 3 or 4
TOWING REVERSING
FRONT
MOUNT
33-100-P 540 RPM 540 RPM 1000 RPM
LOADER REQUIREMENTS
Hydraulic Flow 40 - 50 GPM