SnowWolf AlphaBlower 33-100-H, Operation & Maintenance Manual

Page: 45 / 98

43 AlphaBlower Operation and Maintenance Manual
Maintenance
Lubrication
PTO Shaft
Figure 1
Grease the PTO shaft fittings (Item 1), bearing for
the guard (Item 2) and telescoping tubes (Item 3)
[Figure 1] every 40 hours of operation.
NOTE: For lubrication of the telescoping tubes
(Item 3) the PTO shaft must be pulled
apart.
Grease the bearings (Item 4) [Figure 6] by the
shear bolt every 250 hours of operation.
PTO Stub Splines
Lubricate the splines on the PTO stub using
grease before the snow blower is placed in
storage after the end of the season. Lubricate the
locking bolt on the connection frame using oil.
Spline Pins Front Mount Gearbox
Grease the zerk on the lower axle of the gearbox.
Gearbox Oil Change
Figure 2
NOTE: Make sure the snowblower is level.
Remove the drain plug located on the bottom of
the gearbox and the filling / level plug (1)
[Figure
2] . Drain oil into a container and dispose of
properly.
Install the drain plug and add oil until the oil is
level with the bottom of the fill / level plug hole.
Install the plug.
Fluid such as engine oil, hydraulic fluid,
coolants, grease, etc. must be disposed of
in an environmentally safe manner. Some
regulations require that certain spills and
leaks on the ground must be cleaned in a
specific manner. See local, state and federal
regulations for the correct disposal.
Gearbox Oil Change for Front Mounted Units
Follow the same procedure above for the front
mounted gearbox.
1
3
1
4
2
2
1