SNOWJOE SunjoeTRJ608E, Operator'S Manual

Page: 9 / 16

9
m
WARNING!
Do not operate the grass trimmer in a tree,
on a ladder, or on a scaffold; this is extremely dangerous.
m
CAUTION!
Always wear eye protection.
1. For best cutting performance, hold the trimmer at an angle
of approximately 10 – 30 degrees to the work area
(Fig. 11).
2. Slowly swing the trimmer from side to side (Fig. 12).
3. Do not overload your trimmer; instead, take small “bites”
of grass, working from the top to the bottom. This will
keep the machine operating at high speed and will greatly
improve its cutting efficiency (Fig. 1 3).
Advancing Trimmer Line
Your trimmer uses 0.063 in. (1.6 mm) diameter nylon line to
cut grass and weeds quickly and easily. For efficiently feeding
the line, the trimmer is equipped with semi-auto line feeding
system, which will automatically advance the trimming line
every time the trimmer is stopped and restarted. The excess
line will be cut by the line trimming blade during operation.
Users can also manually advance the line using the line feed
button, following the instructions below.
1. Turn off the machine and unplug the appliance cord, wait
until the spool comes to a complete stop.
2. Turn over the trimmer. While gently pulling out the line,
keep pressing and releasing the line feed button until the
trimming line is long enough to reach the line trimming
blade (Fig. 14).
NOTE: The machine will release only 0.2 inch (5 mm)
trimmer line every time the line feed button is pressed. To
keep advancing the line, make sure to release the line feed
button and press again, until the line reached the desired
length.
NOTE: Make sure the end of the line won't pass the line
trimming blade. If too much line is fed out, remove the
spool cap and turn spool counter-clockwise until the line
is at the desired length.
3. Plug the appliance cord and resume working.
10° – 30°
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Line feed button
Pull out the line
Line trimming blade