11
You can purchase a 6-pack replacement pre-wound spool
(Model TRJ608E-RS-6PK) and other genuine replacement
parts by visiting us online at sunjoe.com or calling our toll-free
customer service helpline at 1-866-SNOWJOE
(1-866-766-9563). The use of parts that do not meet the original
equipment specifications may lead to improper performance
of the grass trimmer, may compromise operator safety and will
void the manufacturer's warranty.
Winding the Line
NOTE: A 6-pk single-line factory wound spool (model
TRJ608E-RS-6PK) is available for easy spool replacement
on the TRJ608E electric grass trimmer. Visit sunjoe.com to
purchase this accessory online. Should you wish to wind the
line yourself, the instructions are provided below. Self-winding,
however, is NOT recommended because if the line is not wound
properly it can cause the trimmer’s semi-automatic feed system
to malfunction. For this reason, users are strongly urged to
purchase the pre-wound spool.
1.
Turn off and unplug the grass trimmer. Make sure the
spool has come to a complete stop.
2. To remove the spool from the trimmer hub, follow steps
1 and 2 from the section "Replacing the Spool + Clearing
Jams and Tangled Lines" beginning on page 10.
3.
Measure and
cut a 9.8 ft (3 m) piece of new trimming
line. Insert the end of the trimming line into the small hole
located inside of the spool (Fig. 19).
4. Bend the trimming line 180 degree around the hole,
secure the bending part with your left hand thumb, and
use your right hand to wind the line according to the
arrows on the spool (Fig. 20). Use slight tension to make
sure the line is tight around the spool.
5. Re-install the spool as instructed in steps 3 to 4 of
"Replacing the Spool + Clearing Jams and Tangled Lines".
m
CAUTION!
Catapulted pieces of nylon line may cause
injury.
m
WARNING!
Pay attention to the winding direction.
NOTE: Always replace the spool with a new pre-wound spool.
Visit sunjoe.com to purchase the pre-wound spool
(model TRJ608E-RS-6PK) for this electric grass trimmer.
IMPORTANT: Keep all areas of the cutting head and cutting
head cover clean. Place the cap back by pushing it firmly
onto the cutting head. To ensure that the cutting head cover
is correctly fitted, try to remove it without depressing the two
tabs. If it is correctly fitted, it should not move.
Storage
Follow these recommendations for storing the trimmer.
•
Clean the trimmer thoroughly before storing.
•
Store the trimmer in a stable and safe position out of the
reach of children. Keep the trimmer in a dry place where the
temperature is not too hot or too cold.
• When storing the trimmer, do not rest it against the floor.
Hang it by the upper handgrip so that the guard does not
touch anything. If the guard rests against a surface, its
shape and dimensions could be permanently altered, and
could render the machine unsafe to use.
Fig. 19
Trimming line
Spool
Fig. 20
Trimming line
Spool
Bend the line
Summary of Contents for SunjoeTRJ608E
Page 16: ...sunjoe com ...
