8
Figure 14
4. Slide the upper chute crank into the lower chute crank, aligning
the screw holes. Tighten the screw into the aligned holes
using a screwdriver. Fasten the nut with wrench (Figs. 14
and 15).
A-Upper chute crank
B-Lower chute crank
C-Screw
Figure 15
A-Upper chute crank
B-Lower chute crank
C-Screwdriver
D-Wrench
E-Nut
F-Screw
Figure 16
5. Remove the washer and nut from the eye bolt with rubber
grommet found on the upper chute crank. Position the chute
crank so that the eye bolt with rubber grommet inserts into
the center hole of the middle frame. Secure with washer
and nut (Figs. 16 and 17).
Note:
Do not overtighten the nut.
A-Eye bolt with rubber grommet
B-Upper chute crank
C-Middle frame
D-Center hole
Figure 17
A-Upper chute crank
B-Eye bolt with rubber grommet
C-Middle frame
D-Washer
E-Nut
F-Wrench
SJ622U1_MANUAL_ENG REV_Document 1 9/2/10 2:32 PM Page 8
