15
Figure 31
3. Replace the large belt by following instructions in
reverse order.
Automatic Reset
The Snow Joe 622U1 has a built in automatic reset function.
In the event of a major obstruction halting the auger, simply
unplug your unit, clear auger obstruction, wait 60 seconds and
resume use.
Replacing the Belt
Note:
Determine the left and right hand sides of the snow thrower
by standing behind the unit in the normal operating position.
1. Remove the screws from the left panel of the snowthrower.
2. Lift the belt tension and roll the large belt off the big pulley
(Fig. 33).
Storage
1. Allow the engine to cool and clean the snow thrower
before storing or transporting. Be sure to secure the unit
while transporting.
2. Disconnect the extension cord from the snow thrower.
3. Inspect the extension cord closely for signs of wear or
damage. Replace it if it is worn or damaged.
4. Inspect the snow thrower carefully for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. For repairing or replacing parts,
contact your Snow Joe dealer or Snow Joe customer
service at 1-866-SNOWJOE.
5. Store the unit, along with the disconnected extension cord,
in a locked, dry place out of the reach of children to prevent
unauthorized use or damage. Cover loosely with a tarp for
added protection.
Service and Support
If your Snow Joe 622U1/623U1 Ultra snow thrower requires
service or maintenance, please call 1-866-SNOWJOE for
assistance.
Model and Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
on the main cover of the unit to the left of the discharge chute.
Copy these numbers into the space provided below.
A – Big pulley
B – Belt tension
C – Large belt
Model #:
Serial #:
Please record the following numbers from the decal on the main cover of
your new product:
SJ622U1_MANUAL_ENG REV_Document 1 9/2/10 2:33 PM Page 15
