9
Operation
Note: Before using this machine, make sure that the power
source you will use complies with the specifications detailed in
this manual. Before inserting the plug into the socket, verify
that the snow thrower!s roll shaft and rubber plates are firmly
secured with screws, and that the rubber plates are facing the
correct direction. Perform a test run to ensure that the rotor
turns freely.
Securing the Extension Cord
1. For safe and efficient use of your snow thrower, use only
a UL-rated extension cord recommended for outdoor use.
Refer to the Extension Cord Chart that follows.
WARNING
m
m
Electric shock may cause SEVERE INJURY or
DEATH. Heed these warnings:
!
Do not allow any part of snow thrower to make
contact with water while powered on. If the appliance
becomes wet while turned off, wipe dry before
starting.
!
Use only a UL-rated extension cord for outdoor,
all-weather use. Do not use an extension cord
over 150 feet (46 meters).
!
Do not touch the appliance or its plug with wet hands
or while standing in water. Wearing rubber boots
offers some protection.
Cord length is:
25 ft. (7.62 m) 50 ft. (15.24 m)
Wire gauge is: 14AWG 12AWG
EXTENSION CORD CHART
2. To prevent the extension cord from disconnecting during
use, tie the female end of the extension cord into a
loose knot on the top right side of the middle frame
before connecting to the male plug in the switch housing
socket of the snow thrower (Fig. 20).
Figure 18
A-Switch housing
B-Polarized plug
C-Upper frame
D-Cord tied to middle frame
E-Middle frame
3. Note that the snow thrower has a polarized male plug,
with one prong in the switch housing socket slightly longer
and wider than the other (Fig. 19). The extension cord
female end should be likewise polarized, so that the
extension cord fits snugly into the switch housing socket.
Figure 19
A-Switch housing
B-Polarized plug
SJ622U1_MANUAL_ENG REV_Document 1 9/2/10 2:32 PM Page 9
