Lit. No. 30118, Rev. 00
June 15, 2020
10
BLADE, T-FRAME & HEADGEAR
T-FRAME TO BLADE ASSEMBLY
1. Remove the blade wings from the crate.
Remove the four shipping straps, then replace
the cutting edge hardware.
2. Align the hinges of each wing. Position the
T-frame assembly between the blade wings so
the holes in the T-frame are aligned with the
holes in wing hinges.
3. Insert the pivot pin from top to bottom through
all hinges as shown.
4. Move the snowplow into a normal operating
position.
5. Remove the protective packaging from the
angle rams.
6. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of
the blade.
7. Install a 1/2" x 2-7/8" clevis pin (from the
shipping bracket) from the top down to
attach each rod. Secure the clevis pins with
5/32" x 1-1/2" cotter pins from the parts bag.
Pivot Pin
1/2" x 2-7/8"
Clevis Pins
5/32" x 1-1/2" Cotter Pins
