Lit. No. 30118, Rev. 00
June 15, 2020
11
BLADE, T-FRAME & HEADGEAR
Pivot
Pin
3/8" x 1-1/2"
Cap Screw
3/8"
Locknut
Blade
Guide
5/16"
Locknuts
5/16" x 1"
Cap Screws
8. Install the center snow de
fl
ector using two
3/8" x 1-1/2" cap screws and 3/8" locknuts.
9. Install the blade guides with 5/16" x 1" cap
screws and 5/16" locknuts, as shown.
CENTER DEFLECTOR AND BLADE GUIDES
ANGLE RAM ADJUSTMENT –
RDV™ BLADE
The RDV V-plow has adjustable angle rams with
two possible mounting positions at the base end
of each ram, nearest the vehicle. This feature
provides a means for making an adjustment in
available ground clearance for when the snowplow
is fully raised and in full angled or retracted (vee)
positions. The angle rams are installed from the
factory in the inner holes (position A). If additional
ground clearance is desired, reposition the
rams to position B, being sure to use the same
corresponding hole for attaching each ram.
NOTE: Failure to make the adjustment or
failure to use the same corresponding holes
for attaching the rams could result in poor
performance or damage.
Position A
Position B
