8
Assembly and Use
Find a flat location for assembly, and ensure that it is clean so
that no dirt will adhere to the fuel canister connectors on the
bottom surface.
1. Removing the cover and the stands.
(1) Slowly raise the cover and windscreen while pressing the
lock spring on the side of the cover with your finger, as shown
in the diagram below. Press in the lock spring until it reaches
the same surface as the cover, then raise the cover until it
comes off completely. Take care not to press the spring too
much, as this will damage it.
(2) Remove the two stands stored on top of the trivets. The
stands are stored with tension applied to their inner sides. You
can easily remove them by gently pulling them outwards.
2. Attaching the stands
(1) Remove the trivets stored inside the stove. The trivets are
detached from the stove. There is the risk of the trivets falling
out while the stands are being attached, so be sure to remove
them before doing so.
(2) Insert the ends of the stands into the holes on the left and
right sides of the stove. The ends can be inserted smoothly by
slightly pulling them apart.
3. Attaching the cover with windscreen
(1) Pull down the stoppers on the bottom of the windscreen
stored inside the cover. This will cause the screen to open. To
close the screen, fold it down with the left-hand screen on top
and then push the stoppers up to secure it in place.
Lock spring
Fully insert them until
the grooves on the top
of the stands are no
longer visible.
Windscreen
Groove
Stand
