25 • EN
Return to contents
Do not over tighten to prevent possible damage to the sensor.
Hex Wrench
Do not over tighten the security screw to avoid damaging the
thread on the tyre valve.
Once the sensors are fitted follow steps 1- 6 in section 10.4.1 then:
1. Press ‘Set using valve’ button
(1)
2. A pop up window will appear in the TPMS display and the button on
the Bluetooth interface will flash red and the interface will ‘beep’ The
interface will now search for a period of 90 seconds for a sensor which is
transmitting a code. Once the code has been received, it will replace the
six zeros and the interface will beep.
3. Press the return button
(1)
to save or the exit button
(2)
to cancel
4. Repeat steps 1 & 2 for each subsequent wheel
5. Once all of the sensors are programmed press the exit button
(6)
THREE
times to fully exit TMPS
10.4.2 Installing 116 PSI sensors
1. Unscrew the tyre valve cap and replace with the tyre sensor.
2. Use the wrench provided to tighten the screw for added security.
User tip: Please keep the wrench in a safe place for when you next need it.
Replacing the sensor battery
1. Use the hex wrench provided to remove the anti-theft screw and remove the sensor from the tyre valve.
2. Use the battery replacement tool to unscrew the sensor cap.
1
2
3
screw
MySpeed DVR V1.0 GB 08/17
Summary of Contents for My-Speeed DVR
Page 1: ...User manual...
