Sno-Way 28V Series, Owner'S Manual, Page: 16 / 32

15
Fluid leaking at Pump Assembly Hydraulic fittings not torqued
properly (too tight, too loose) Refer to Dealer
O-Rings between valve block and
endhead are cut or not seating
properly Refer to Dealer
O-Rings between endhead and
reservoir cut or not seating properly Refer to Dealer
Reservoir over-full See Maintenance Section
O-Ring on solenoids or pressure
switches defective Refer to Dealer
Endhead cracked Refer to Dealer
Valve body cracked Refer to Dealer
Unit lifts but does not hold - first
action Dirt in check valve or Float/DP
solenoid valve Cycle raise and lower system to flush
debris
Float/DP solenoid valve sticking Cycle raise and lower system to un-
stick valve
Unit lifts but does not hold -
second action Dirt or debris in check valve Refer to Dealer
Check valve spring broken Refer to Dealer
Float/DP solenoid valve sticking Refer to Dealer
Seals O-Ring(s) on Float/DP
solenoid valve damaged Refer to Dealer
Raise/lower ram defective Refer to Dealer
Machine failure Refer to Dealer
Unit will not lower
NOTE: Only in non- down pres-
sure mode
Plugged breather cap See Maintenance Section
Low or no current available at Float/
DP Solenoid Refer to Dealer
Float/DP solenoid valve sticking Refer to Dealer
Float/DP solenoid coil defective Refer to Dealer
Raise lower ram defective allowing
movement in one direction only Refer to Dealer
Machine failure Refer to Dealer
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION