Sno-Way 28V Series, Owner'S Manual, Page: 11 / 32

10
Figure 1-5
8. Plug plow light connectors into mating connectors on
truck light harness (See Figure 1-6).
Figure 1-6
9. Plug control harness on plow into truck. Plug plow
control inside truck cab.
10. Raise, lower and angle plow to make sure no hoses
or wires pinch in the plow mechanism.
Installing The Cylinder Lock Clamp
1. Raise the plow to the full UP position.
2. Turn the ignition OFF and apply the parking brake.
3. Turn OFF the hand-held controller.
4. Remove the pin from the cylinder lock clamp.
5. Position the cylinder lock clamp around the exposed
(chrome) portion of the lift cylinder with the open side of
the cylinder lock up. Install the pin. (See Figure 1-7).
Figure 1-7
6. Lower the plow so that cylinder lock clamp is tight
against cylinder.
c
WARNING
Failure to properly connect plow lights to
vehicle light harness will prevent plow lights
from functioning. Follow proper procedure to
connect light harnesses and test lights before
operating.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH
PLOW LIGHT
CONNECTORS
TRUCK LIGHT HARNESS
CONNECTORS
PLOW CONTROL HARNESS
PLOW LIGHTS
CONNECTED TO TRUCK
LIGHT HARNESS
c
WARNING
Always install the cylinder lock clamp when the
plow blade is raised and the operator is not
engaged in plowing operations. Equipment
failure or inadvertent operation of the plow
control while driving could allow the plow blade
to fall, resulting in injury.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH
c
WARNING
Failure to lower plow onto clamp could block
headlights resulting in an accident.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH
WIRE LOCK PIN
LIFT
LINK
A-FRAME BOTTOM
BELL
CRANK
CYLINDER
LOCK
CLAMP
CYLINDER
ROD