Sno-Way 28V Series, Owner'S Manual, Page: 13 / 32

12
7. Disengage lower jack stand pin by pulling on handle.
Lower the jack stand and engage the top pin by pushing
on the handle. Make sure pin is engaged in hole by
rotating jack stand back and forth.
Figure 1-12
8. Remove controller from truck cab and plug into plow
control harness.
9. Rotate jack stand down and raise A-frame by
pressing the up button. (See Figure 1-13).
Figure 1-13
10. Disconnect power harness, replace protective caps
and back truck away from plow.
Plow Storage
1. If the plow will not be stored on a firm surface (i.e.
concrete or asphalt), place a board or piece of plywood,
etc. under the jackstand to prevent the jackstand foot
from sinking into the ground.
2. To avoid corrosion during storage, coat the exposed
(chrome) portion of the lift and angle cylinders with a light
grease.
3. Grease all pivot points.
4. Top off hydraulic reservoir to minimize trapped air.
5. Make sure that protective caps are on all electrical
connections. Apply a small amount of dielectric grease to
ensure a moisture proof seal on the caps.
6. Check and replace any worn and/or damaged
component, such as cutting edges or deflectors.
Performing preventative maintenance tasks in the spring
when plow is stored will ensure that you will be ready to
plow in the fall.
BELL
CRANK
JACK
STAND
LIFT LINK
UPPER PIN
HANDLE