Sno-Tek 920402-Sno-Tek 24E, Operator'S Manual

Page: 8 / 38

GB - 8
PACKAGE CONTENTS
ASSEMBLY
Tools Required:
• Pliers
• Open-end wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or adjustable wrench
• Tire gauge
Unfold Handlebar
(Figure 4)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the sixth
forward position.
4. Rotate the handlebars into operating
position.
NOTE: Be careful not to damage cable spring
hooks when rotating handlebars upward.
5. Install and tighten the hardware on the
handlebar assembly and shift rod.
6. Check tension on auger and traction
clutch cables.
IMPORTANT: Cables should not be slack nor
under tension. Adjust as necessary.
.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
Figure 3
1. Sno-Tek™ Unit
2. Discharge
Chute
3. Chute Crank
4. Literature Pack
1
2
4
3
Figure 4
1
2
3
1. Shift Rod
2. Upper and Lower Handlebar
Hardware
3. Shift Rod Hardware
4. Handlebar
4