Sno-Tek 920402-Sno-Tek 24E, Operator'S Manual

Page: 30 / 38

GB - 30
Engine stops. 1. Out of fuel.
2. Fuel shut-off valve
closed.
3. Mechanical jam in auger
or impeller.
4. Contaminated fuel supply.
5. Faulty spark plug.
6. Plugged fuel cap vent.
1. Fill fuel tank. DO NOT
OVERFILL! (see Filling Fuel
Tank on page 15) .
2. Open fuel shut-off valve.
3. Turn off engine, remove key,
and wait for all moving parts to
stop. Check for and remove
obstruction and repair before
restart.
4. Replace with clean fuel.
5. Replace or clean spark plug.
6. Replace fuel cap.
Engine
problems. 1. See Engine Manual. 1. See Engine Manual.
Does not
operate in
Forward /
Reverse.
1. Friction disc worn out.
2. Traction belt not
functioning.
3. Speed selector not
adjusted properly.
1. Replace friction disc (see
Replace Attachment Drive Belt
on page 25).
2. Repair or replace traction drive
belt (see Traction Drive Belt
Replacement on page 26).
3. Adjust speed selector (see
Speed Selector Adjustment on
page 22).
Small rubber
beads collect
in frame 1. Friction disc wear. 1. Normal friction disc wear.
Chunks or large pieces of
rubber mean friction disc
should be checked and
replaced as necessary.
Unit throws
snow poorly
or does not
throw snow. 1. Shear bolts broken.
2. Attachment clutch/brake
not adjusted properly.
3. Auger is frozen in place.
4. Ice or debris is
obstructing auger.
5. Attachment drive belt
slipping, worn or
damaged.
1. Replace shear bolts (see Shear
Bolts on page 21).
2. Adjust attachment clutch/brake
(see Attachment Clutch/Brake
Adjustment
on page 23).
3. Move unit to a warm place to
thaw.
4. With the engine off and auger
disengaged, check for
obstructions and remove.
5. Adjust or replace attachment
drive belt (see Attachment
Clutch/Brake Adjustment on
page 23).
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION