GB - 14
Speed Selector
Position the speed selector in the appropriate
speed notch to control forward and reverse
travel.
Forward:
(6) Fastest
(1) Slowest
Reverse:
(1) Slow
(2) Fast
IMPORTANT:
DO NOT change motion from
forward to reverse with clutch engaged.
Forward speed can be changed without
declutching.
Fuel Shut-Off Valve
IMPORTANT:
The fuel shut-off valve MUST
be in the closed position prior to transporting
the unit.
The fuel shut-off valve has two positions:
Open Position (1):
Use this position to
run the unit.
Closed Position (2):
Use this position to
service, transport, or
store the unit.
Choke Control
1. Choke Closed position: chokes off air to
engine for easier start.
2. Choke Open position: allows for normal
operation.
IMPORTANT:
Gradually open choke after
engine starts.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT:
DO NOT let handle snap back
against starter.
Snow Clean-Out Tool
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
Manual Discharge Chute Deflector
(920404)
ALWAYS position discharge chute deflector
at a safe angle before starting engine.
DO NOT throw snow any higher than
necessary.
Push deflector handle forward or down to
throw snow lower. Pull deflector handle up or
to the rear to throw snow higher.
IMPORTANT:
If chute deflector does not stay
in set position, adjust as directed in
on page 20, or repair
before operation.
08000712
OFF
ON
1
2
START
RUN
2
1
WARNING:
Hand contact with the
rotating impeller is the most common
cause of injury associated with snow
throwers. Never use your hand to
clean out the discharge chute.
1
Figure 10
1. Snow Clean-Out Tool
Summary of Contents for 920402-Sno-Tek 24E
Page 37: ......
