GB - 20
GENERAL LUBRICATION
IMPORTANT:
Wipe each fitting clean before
and after lubrication.
IMPORTANT:
DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTE:
Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
The unit should be lubricated (Figure 14) at
beginning of season or every 25 operating
hours.
Auger Shaft
NOTE:
To grease auger shaft, remove shear
bolt nuts, and shear bolts. Apply grease at the
grease zerks and then turn the auger
assemblies on the auger shaft. Replace
shear bolts per instructions in
SCRAPER BLADE
IMPORTANT:
Damage to housing will result if
blade wears down too far.
Scraper blade is adjustable to compensate
for wear.
To adjust scraper blade:
1. Tip unit back onto handlebar, support
housing and loosen nuts retaining blade.
2. Reposition scraper blade and tighten
lock nuts.
3. Ajust skid shoes.
Grease
Figure 14
Oil
2x
SERVICE AND ADJUSTMENTS
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
Summary of Contents for 920402-Sno-Tek 24E
Page 37: ......
