Sno-Tek 920402-Sno-Tek 24E, Operator'S Manual

Page: 21 / 38

GB - 21
SKID SHOES
(Figure 15)
Skid Shoes should be adjusted as conditions
require.
1. Position unit on a hard, flat, smooth level
surface.
2. Adjust skid shoes by inserting a spacer
of desired thickness under center of
scraper blade, loosen skid shoe
hardware, slide skid shoes to flat
surface. Allow 1/8 in. (3 mm) between
scraper blade and hard smooth
surfaces. Allow 7/8 in. (22 mm) between
scraper blade and uneven or gravel
surfaces. Retighten hardware.
NOTE: Keep housing level by adjusting skid
shoes equally.
SHEAR BOLTS
(Figure 16)
IMPORTANT: Use only Ariens OEM shear
bolts for replacement. Use of any other type
of shear bolt may result in severe damage to
unit and may void the warranty.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger,
breaking shear bolts which secure the auger
to the shaft. This allows auger to turn freely
on the shaft which may help prevent damage
to gear case and its components.
For Replacement:
1. Align shear bolt holes in auger with
shear bolt holes in the shaft.
2. Drive shear bolt through hole (if shear
bolt was broken this will drive remaining
part from shaft).
3. Secure shear bolt with nut.
DISCHARGE CHUTE DEFLECTOR
(920404)
(Figure 17)
Deflector must stay in selected position while
throwing snow.
To adjust, loosen then retighten the wing
knob to desired tension.
Figure 15
OS0482
1. Skid Shoe
2. Skid Shoe Hardware
1
2
Figure 16
1. Auger
2. Shear Bolts
1 2
Figure 17
1. Wing Knob
2. Discharge Chute Deflector
3. Discharge Chute
1
2
3