EN – 34
6.
Remove top locking flange nut, compression spring,
friction plate and friction washer from round head
square neck bolt.
7.
Remove round head square neck bolt and chute
rotation gear.
IMPORTANT:
Friction washer and flat steel washer may
remain in original positions. See detailed view in Figure 74.
Install Chute Rotation Gear
1.
Position discharge chute facing forward.
2.
Position chute rotation gear on chute mount so gear
edge is square with chute mount bracket.
IMPORTANT:
Make sure flat steel washer and friction
washer are positioned between chute mount bracket and
pedestal plate. See Figure 75.
3.
Insert round head square neck bolt through chute
gear.
4.
Reinstall friction washer, friction plate and
compression spring onto bolt and secure with top
locking flange nut.
IMPORTANT:
Make sure notch in friction plate aligns with
tab on chute mount bracket.
5.
Secure pinion gear bracket to pedestal plate with two
tapping screws.
6.
Reinstall chute rotation rod into pinion gear socket and
secure with spring clip.
7.
Reinstall chute gear cover and secure with tapping
screw.
8.
Reconnect spark plug wire.
9.
Adjust discharge chute. Refer to Operator’s Manual
for adjustment procedure.
IMPORTANT:
Check all adjustments after first use.
Figure 74
Figure 75
1. Friction Plate
2. Chute Mount Bracket
