EN – 14
7.
Reconnect idler spring to traction drive idler.
8.
Reconnect swing gate return spring to frame.
9.
Reinstall housing to frame. See
10. Adjust traction drive clutch. Refer to Operator’s
Manual for adjustment procedure.
11. Reconnect spark plug wire.
IMPORTANT:
Check all adjustments after first use.
ATTACHMENT BRAKE REPLACEMENT
Remove Attachment Brake
IMPORTANT:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Remove auger housing. See
4.
With a flathead screwdriver or similar pry bar,
disconnect extension spring from frame.
5.
Remove hardware securing brake arm to brake mount
bracket and remove brake arm.
6.
Remove extension spring from brake arm.
Install Attachment Brake
1.
Reinstall hex bolt through brake mount bracket.
2.
Install extension spring onto brake arm.
3.
Reinstall sleeve bushing into attachment brake arm
and install brake arm onto hex bolt. Secure with top
locking flange nut, but DO NOT overtighten.
4.
With a flathead screwdriver or similar pry bar,
reconnect extension spring to frame.
See Figures 23 and 24.
5.
Engage and disengage attachment clutch to verify that
brake roller on attachment idler does not interfere with
brake pad.
IMPORTANT:
Make sure brake roller does not bind.
Figure 21
Figure 22
