Sno-Tek 24E, Service Manual

Page: 31 / 44

EN – 29
Install Traction Drive Cable
1. Install cable eyelet onto swing gate and secure with
flat steel washer and hairpin.
IMPORTANT: Hairpin must be reinstalled in the orientation
shown in Figure 60 so it does not interfere with swing gate
return spring.
See Figure 61.
2. Route cable end through hole in frame rear.
3. Align cable in cable pulley and tighten shoulder bolt.
4. Connect upper traction drive clutch cable to lower
cable.
5. Reinstall upper traction drive clutch cable to traction
clutch lever. Secure with one flat steel washer and
hairpin. See Figure 58.
6. Reinstall bottom cover and secure with six hex
screws.
7. Return unit to operating position.
8. Reconnect spark plug wire and fill fuel tank.
9. Adjust traction drive clutch. Refer to Operator’s
Manual for adjustment procedure.
IMPORTANT: Check all adjustments after first use.
AXLE BUSHING REPLACEMENT
Remove Axle Bushing
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position and remove bottom
cover. See
Service Position on page 7 and Bottom
Cover Removal on page 11.
4. Remove wheel from side of unit receiving a
replacement bushing.
5. Place speed selector lever in the fastest forward
position.
See Figure 62.
6. Remove sleeve bushing from axle.
7. Remove hardware securing axle bushing to frame and
remove bushing.
IMPORTANT: If replacing bushing on right side of frame,
remove roll pin from left side of axle and move axle and
spur gear left to access hardware. See Figure 63.
Figure 61
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
Figure 62