Home-Pro 3000 Assembly Instructions
12 of 25
Figure 4. Connect Angle Ram Cylinders to Trip Frame
Swin
g A-
Fra
me
L&
R
to
ins
ert
Pin
s
1" x 4" Clevis Pin
1" x 4" Clevis Pin
3/16" x 2"
Cotter Pin
Section 4. Lift Frame Side Plate Install
A.)
Locate both L&R Lift Frame Side Plates (1TBP112A&B) and slide (1) onto each side of the A-Frame
Hinge Pin.
Figure 5.
B.)
Slide the L&R Torsion Springs (1TBP33A-1 & 1TBP33A-2) over Hinge Pins with the 90º bent ends
inside the hole in the Spring Keeper on the corresponding Side Plate. The straight Spring Legs should
be resting on the A-Frame Spring Stop.
Refer to Figures 5 on the next page & Figure 8 on page 15.
C.)
Install Torsion Spring Bushings (1TBP113) through the Torsion Springs and over the Hinge Pins.
Fasten loosely with (1) 1/2"-13 x 1" Patch Bolt and 1/2" Flat Washer threaded into each Hinge Pin to
secure the assemblies.
Do Not
tighten Bolts at this time. Repeat procedure on opposite side.
D.)
Using the A-Frame as a lever, grasp the A-Frame near the Side Plates at the top of the assembly and
pull back, raising the Moldboard to the vertical position.
E.)
Secure one end link of the Lift Chain to the middle hole in the Chain Bracket on the A-Frame
using (1) 5/16" Chain Shackle supplied in Plow Hardware Bag.
See Figure 6.
The 3 mounting holes are used to fine-tune the attachment and lifting
performance of the Plow on a specific vehicle. The middle hole is a good
starting point.
F.)
Install (1) Blade Marker at each end of Moldboard Top Tube using hardware supplied with Blade
Markers.
Figure 6.
NOTE
