10 of 25
Home-Pro 3000 Assembly Instructions
Section 1. Moldboard Assembly
A.)
Lay Moldboard on its face. Place cardboard under the Top Tube to prevent paint damage.
B.)
Bolt the Trip Frame to the Moldboard at the (6) Pivot Brackets.
Figure 1.
Figure 1. Bolt Trip Frame to Moldboard
Section 2. Mount Trip Springs
A.)
Mount (2) Trip Springs (1TBP33) to Trip
Frame.
B.)
Thread (1) 5/8" Jam Nut half-way onto each
Spring Eyebolt.
Figure 2.
C.)
Slide (1) 5/8" Lock Washer onto each Spring
Eyebolt (1TBP34) and then insert each Eye
bolt into the Spring Brackets on Moldboard.
D.)
Thread (1) 5/8" Locknut onto each Eyebolt.
E.)
Tighten Locknuts to increase tension on
Springs until there is enough space between
the coils to slide a piece of paper.
F.)
Tighten each 5/8" Jam Nut and Lock Washer
against each Moldboard Spring Bracket to
lock the Eyebolts.
G.)
Install Protective End Caps to Eyebolts.
Figure 2. Mount Trip Springs
3/8"-16 x 1" Bolts
Moldboard
Trip Frame
3/8"-16 Lock Nuts
Note direction of Hardware when mounting.
Tighten Jam Nuts on Eyebolts until
correct Spring tension is achieved
End
Cap
End
Cap
A
B
Thread Jam Nut halfway &
add Lock Washer before inserting
through Moldboard Bracket
