Home-Pro 3000 Assembly Instructions
20 of 25
Vehicle to Plow Initial Setup
Once Vehicle Mount Kit and Harness installations are complete, raise the Plow to the same level as the
Mount Kit Receiver. To accomplish this, drive truck close to Plow and attach the Harness Plug. Put 'In-
Cab' Control System into the 'float' position and raise the Plow using the A-Frame Jack Switch to align the
rear of the Lift Frame with the Mount Kit Receiver. If necessary, readjust the Side Plate positions.
Jack Adjustment Procedure
With the Lift Cylinder & Jack fully retracted, top off the Pump Reservoir. It may be necessary to run the
Jack for 10 cycles as a break-in period. During the break-in period, check that the Jack retracts fully
against the Pan of the A-Frame. If the Jack Leg doesn’t fully retract, remove the A-Frame Cover and
manually adjust the tension on the Jack Leg Return Spring using a 1-1/8" open end wrench. The Jack
Return Spring is located forward of the Pump in the A-Frame Pump cavity.
See Figure 15 below.
A 3/4" Hex Nut holds the tension on the Spring. If more tension is required, tighten the Hex Nut against the
Spring. When adjusting the Spring tension, use full turn increments and test the function of the Jack Leg after
each turn of the Hex Nut. Do not over tighten the Return Spring.
Figure 15. Jack Spring Adjustment
A-Frame with Cover removed
Jack Switch
3/4" Hex Nut to adjust Jack Spring
