Home-Pro 3000 Assembly Instructions
19 of 25
Figure 13. Determine X Height for Correct Side Plate Mounting Holes
Section 8. X Height Procedure
A.)
Install Mount Kit on vehicle referring to Mount Kit installation procedure. Wire vehicle referring to
Page 22 for detailed Harness & Control System installation information.
B.)
With vehicle parked on level ground and properly ballasted for snow plow use, measure the distance
from the ground up to the centerline of the Latch Bar on the Receiver as shown.
C.)
Once 'X' dimension is measured, use the Application Chart below to determine which hole locations
to use when attaching the Lift Frame to the Side Plates.
This is a general guideline to help make the assembly process easier.
Due to great variations in suspension, tires, age of the vehicle, etc. it may be
necessary to change the Side Plate positions after Plow is attached to the vehicle.
Figure 14. Select Appropriate Side Plate Mounting Holes
X
Insert Spring End
into Keeper
Top
Center
Bottom
Top
Center
Bottom
If X is 16-3/4" and above use Top Holes
If X is between 15-3/4" to 16-1/2" use Center Holes
If X is below 15-1/2" use Bottom Holes
NOTE
