![background image](http://html1.mh-extra.com/html/snell-and-wilcox/kudos-plus-cvr250/kudos-plus-cvr250_operators-manual_1309055043.webp)
CVR250
SECTION 4
CVR250OPS
20/10/06
www.snellwilcox.com
Version 1 Issue 4
4.23
◀
Status
This menu allows information about the status of
the unit to be displayed.
Status
Status Display...
GPI Delay
Unit Temperature
Software Version
Serial Number
Build Number
Restart
◀
◀
◀
◀
Status Display
Status Display
Default Display
Status Display 1
Status Display 2
Status Display EDH
Reset EDH Status
◀
◀
◀
◀
Default Display
When this item is selected the display window
shows details about the Input Signal, Reference
signal and the output as shown in the example
below.
The first line shows the name of the unit.
The second line shows which input has been
selected and the detected standard of the input
signal.
The third line shows the standard of the output
signal and the genlock status.
The fourth line shows the status of the output
signal and the state of the ProcAmp controls. The
output signal status may be nothing, (output is
processed picture),
Pattern
or
Freeze
.
Note that if Pattern, Black or Freeze has been
forced because of an input signal failure the words
will be prefixed by an asterisk.
e.g.
*
Pattern,
*
Black
or
*
Freeze
.
If the proc amp controls are not preset then
UnCal
appears in the display.
◀
◀
◀
◀
Status Display 1, 2
When these are selected the display window will
be as shown in the examples below.
Status Display 1
Status Display 2
◀
◀
◀
◀
Status Display EDH
When selected the information area will display the
number of errors from the time the function was
enabled. The elapsed time in hours, minutes and
seconds is also displayed. Meanings are as follows:
EDH:
This is the state of the input error
detection handler.
EDH states are:
None
No EDH present in the source.
OK
Correct EDH detected.
Fail
Error in the EDH detected.
N/A
Not applicable to this source type.
Err:
The number of EDH errors that have
occurred since the last EDH reset.
E-Time:
This is time since EDH was reset
in Hours:Minutes:Seconds.
◀
Reset EDH Status
This will reset the EDH error count and the timer
shown in the information window to zero.
CVR250
In:SDI A
525
OUT : NTSC
REF : OK
CVR250
In:CVBS A PAL
RGB: Off
ProcAmp: On NRS: On
CVR250
In:CVBS A PAL
Enhance: Off
RGB: Off
Timing: Off
ARC: Off
CVR250
In:SDI A
625
EDH:None
Err: 0
E-Time:03:06:18