MC1000/MC1000-IQ/MC2000/MC2000-IQ
System Setup Menus
Issue 1 Rev 8
Page 44
© 2015 SAM
7.9.4 Reset to Defaults
Reset to Defaults recalls the unit’s default memory settings at both system and channel level.
All controls are reset to their preset values
except
for the following:
•
Network > DHCP
•
Network > IP Configuration
•
Network > IP Gateway
•
Network > IP Netmask
•
RollCall > Unit Name
7.9.5 Factory Reset
Factory Reset recalls the unit’s default memory settings at both system and channel level. All
controls and user memories are reset to their preset values.
The default settings for IP Configuration is to set the unit to DHCP. Any saved settings for IP
Address, IP Netmask, and IP Gateway are also lost when performing a factory reset. The unit
returns all three to their default settings, which are as follows:
•
IP Configuration: DHCP
•
IP Address: 192.168.151.1
•
IP Netmask: 255.255.255.0
•
IP Gateway: 192.168.151.200
7.9.5.1
Performing a Factory Reset
1.
On the front panel, press the SYSTEM Shortcut button.
2.
Select Memories > Factory Reset, then select Done.
3.
Do one of the following to apply the changes:
•
Select Network > Apply IP Changes, then select Done.
•
Reboot the system.
Note:
Reset to Defaults does not affect user memories.
Factory Reset clears all user memories. Make a note of any important settings before
performing a factory rest.
Note:
If performing a factory reset via a remote link, when you select Apply IP Changes, the
remote link will be lost.
