MC1000/MC1000-IQ/MC2000/MC2000-IQ
RollCall Control Panel Channel Operation Screens
Issue 1 Rev 8
Page 147
© 2015 SAM
11.9.3 Embedding
The Embedding controls enable you to enable/disable embedding of VITC in SD output video,
and to choose the line on which it is embedded for both 525 and 625 outputs.
•
VITC Enable:
Enables the embedding of VITC in the SD output.
Note: This control only enables the embedding of VITC. In order for VITC to be
present in the output SD video, a valid timecode must be detected at the input when in
Follow Input mode, or when Generate mode is selected.
•
Output Line (525):
Selects the output line on which VITC is placed when the channel
output is 525. The range is from line 11 to line 17 in one-line steps. The default is line
14.
•
Output Line (625):
Selects the output line on which VITC is placed when the channel
output is 625. The range is from line 7 to line 20 in one-line steps. The default is line
19.
Note: The line number stated is the first of the two lines used to embed VITC. The
second line will always be the line se 2. For example, the default line for 525
is 14. Therefore VITC will be embedded on lines 14 and 16.
•
Output Line Status:
Shows the actual output line number on which SD VITC packets
are inserted. If no line number is selected, “OFF” is displayed.
Note: If the line selected is already in use, the VANC embedding hierarchy will place
the SD VITC packet on the nearest available line.
