94
ii-1
ii-2
Installation Instructions
ii Transportation, unpacking and contents
Transportation
The wheel balancer is supplied on a pallet.
•
Use a pallet truck (Figure ii-1) to bring the wheel
balancer to its working area.
Unpacking
PREVENT THE STRAPS FROM SPRINGING
LOOSE AFTER BEING CUT
.
•
Cut the straps.
•
Open the top of the box.
•
Remove staples at the bottom of the box. Lift the
box up and over the unit.
•
Carefully unwrap the balancer and spare parts
supplied.
•
Check the contents of the shipment.
Contents
The shipment contains:
- a wheel balancer.
- Documentation with Declaration of Conformity (CE).
- the accessories mentioned in Section 3.1 of the
Operator’s Manual.
- 3 storage hooks and fl anges.
- a mains power cable.
- a wheel guard assembly (if present).
Tools required
- Screwdriver / bar (diameter 5 mm Max)
- Pin / bar (diameter 10 mm Max)
- Wrench
13
mm
- Wrench
1
7 mm
Positioning
•
Remove the bolts that secure the wheel balancer
on the pallet.
DO NOT LIFT OR MOVE THE WHEEL
BALANCER BY THE MAIN SHAFT OR
MEASURING UNIT
.
•
Refer to Figure ii-2. Move the wheel balancer from
the pallet to its working location.
Note
: Use the storage hooks (mount as
instructed in Chapter iii) and/or the wheel guard shaft
(if present) to handle the wheel balancer.
Summary of Contents for Sun SWB 100
Page 90: ...90 Blank Page ...
