40
5.3.5-1
Operation
5.3.5
Check spin
It is good practice to perform a check spin after applying
the weights.
•
Spin the wheel.
If the wheel has been balanced properly, “000” will
be displayed for both planes. To check how much
imbalance is left:
•
Select the fi ne key - Fig. 5.3.5-1.
•
Rotate the wheel by hand.
The weight to be applied is shown on the display.
Note:
The operator should decide if applying the
stated weight is necessary.
5.3.6
Results recalculation
After spinning a wheel it is possible to enter new rim
data or select another weight mode. The results are
recalculated automatically, if possible.
Selecting another weight mode:
- Between NORMAL, ALU and STATIC: no additional
steps required.
•
Select “
fine
” Figure 5.3.5-1 (
Lens
) to toggle
between Weight Application Mode and Data Entry
Mode.
•
State the new plane reference points.
•
Apply the weight(s).
To have a recalculation done:
•
Select the required weight mode. Check and/or edit
rim or plane data when necessary.
•
Rotate the wheel to the left plane WAP position and
apply the weight.
•
Rotate the wheel to the right plane WAP position
and apply the weight.
•
Perform a check spin.
1
Summary of Contents for Sun SWB 100
Page 90: ...90 Blank Page ...
