10
5.5 TOWER POSITIONING AND SETUP
1.
Locate the power side and slave side tower to the relative position as shown on
Figure 3.
Double check all dimensions.
2.
Using a step ladder, install the crossmember. Raise and place the crossmember
mounting hooks over the top of the tower. Install and
tighten
the crossmember
using four (4) 1/2”-13UNC x 1½”LG. hex head bolts, flat washers, lock washers
and hex nuts.
3.
Check the towers to make sure they are located, and positioned in the correct
location. Refer to
Figure 3
.
5.6 ARM INSTALLATION
1.
Remove (4) 5/16”-18UNC x 3/4”LG. hex head bolts that are locking the arm pins
to the arm. Install arms to carriages. Install so that the shorter arms (with the 30
°
bend) are on the front, and the long arms on the rear. Refer to
Figure 6
.
2.
Grease and insert arm pins. Align notch on arm pins to the tapped hole on the
arm. Using the 5/16” hex head bolts removed in previous step, reinstall and
tighten
securely.
NOTE:
Arm restraint device to be installed in Section 5.14.
Figure 6 – Arm Installation
Summary of Contents for EELR326A
