78
Direct LFE + managed bass
The Realiser’s bass management capabilities allows for both the LFE channel and bass redirected from
the main channels to be routed directly into the headphones without a virtual subwoofer.
Follow the instructions for Direct LFE above, and in addition:
Set the factors in the
TAC
mix blocks as follows.
MIX BLOCK L-ch
MIX BLOCK R-ch
L
1.0
R
1.0
C
0.5
C
0.5
AUX
0.5
AUX
0.5
LS
1.0
RS
1.0
all others
0.0
all others
0.0
For each main channel, adjustments must be made as follows, using the left channel as an example.
Press
MENU
, then
L
. The screen will say:
CH1(1) -> L vSPKR
>SHOW SPKR POSITIONS
L vSPKR SETUP1
L vSPKR SETUP2
Use the
v
key to choose
L vSPKR SETUP
1 and press
OK
. The screen will say:
>FILTERS
MIX BLOCK
LFE GAIN:-- dB
LPF MIX:--
The cursor should be on
FILTERS
; if not, use the
v
key to place it there; press
OK
. The
screen will say:
> BASS: OFF
TREBLE: OFF
ROLL OFF: 80Hz
HPF: NO
Use the ^ and
v
keys to place the cursor on a line, and the < and > keys to change the
value. Set
ROLL OFF
to
80 Hz
and
HPF
to
YES
. Press
EXIT
three times to exit
the menus.
You may wish to experiment with higher
ROLL OFF
values for rooms with difficult mode problems.
A setting of
80 Hz
will provide minimal loss of the “out-of-head” experience. Higher settings will
progressively bring localisable frequencies into the head, which is in itself undesirable but which may
be an acceptable tradeoff for certain rooms with pronounced mode problems.
