20
TD
-- tracker disable -- disables head tracker (including tilt detector) and monitor bridge
Remote control SVS-RC2
The earlier remote control SVS-RC2 works the same, except that some buttons have different names.
The table below shows the corresponding buttons for the two remote controls.
RC2
RC3
Function
VPOS
METR
see
METR
CLR
REF
see
REF
OFFS
MODE
see
MODE
SUB
TC
see
TC
VDIS
INFO
for future use
[none]
P
for future use
[none]
AX1
for future use
[none]
AX2
for future use
The control menu
The Realiser is typically operated by means of the IR remote control. It can also be controlled via
USB, using the
USB REMOTE
port on the rear panel, or via a UART interface, using the
HT-CHARGE
socket on the front panel. (The
USB REMOTE
socket is USB compliant; the
HT-CHARGE
socket is not.)
Each of these control interfaces can be enabled or disabled via the
CONTROL MENU
. To access this
menu:
Press
(!)
. The screen will say:
>SAVE SYSTEM CONFIG
UPDATE REALISER SW
CONTROL MENU
PASSWORD OPTIONS
Use the
v
key to Choose
CONTROL MENU
.
The screen will say:
CONTROLLER OPTIONS
> IR REMOTE:Y
WIRED REMOTE:N
USB REMOTE:N
Use the ^ and
v
keys to choose the setting of interest, and the < and > keys to toggle between
Y
(enable) and
N
(disable). When
IR REMOTE
is set to N, the Realiser will be unresponsive to all IR
remote control keystrokes
except
TC
, which restores the IR remote control.
To save a controller setting, press
EXIT
to come up one menu level, choose
SAVE SYSTEM
CONFIG
, and press
OK
.
When
IR REMOTE
is toggled to
N
, the setting is automatically saved. This is because the remote
control is locked out and the user , typically having no wired controller, has no way of saving the
setting manually. When the Realiser is powered down and back up, the remote control will still be
disabled. Setting
IR REMOTE
to
Y
, and setting
WIRED REMOTE
and
USB REMOTE
to
Y
or
N
,