8
How a fan convector works
Hot water from your central heating
system passes through the heat exchanger
transferring its heat to the aluminium
fins. Cooler air is drawn in by the fan and
heated as it passes over the heat
exchanger before being expelled gently
back into the room. This not only gives a
more even temperature spread but will
heat a room up in less than half the time
of a traditional steel panel radiator.
Fan convectors include an internal water temperature thermostat that prevents the fan
from operating until the central heating system water passing through the heat exchanger
reaches 42ºC. This prevents cooler air being circulated at start up.
Heating
-
see diagram
Ensure your central heating system is
ON
. Switch on the heater (the neon switch will
illuminate). Set the thermostat control (if fitted) to the desired temperature. Set the
heat-output switch to medium output setting. Providing the water temperature in the
central heating system is more than 42ºC and the thermostat (if fitted) is calling for heat
the product will switch on. If you require a faster warm up move the heat output switch to
boost. When the room reaches the desired temperature you may move the heat-output
switch to low.
LOW
MEDIUM
BOOST
OFF
ON
Fault Finding
This heater is covered by a free five-year parts & labour guarantee. In the event of
difficulty please contact our After Sales Service on 01245 324560. It will be helpful if you
do not disconnect the heater from the central heating system.
Smith's Environmental Products Ltd.,
Blackall Industrial Estate, South Woodham Ferrers, Chelmsford, Essex CM3 5UW
Tel: 01245 324900 After Sales: 01245 324560 Fax: 01245 324422
E-mail: [email protected] Web: www.smiths-env.com
In light of our policy of continuous development Smith’s Environmental Products Ltd reserve the right to alter
specifications without prior notice.
04-1117
Aug 07
