Smithco Spray Star 1000, Parts & Service

Page: 103 / 112

103
Accessories
10-417 CHEMICAL CLEAN-LOAD
®
PART LIST
REF# PART # DESCRIPTION QUANTITY
3 HBFL-516-18-075 Flange Bolt
5
/
16
-18 x
3
/
4
4
HNFL-516-18 Flange Lock Nut
5
/
16
-18 4
4 15-620 Clean-load Eductor 1
5 18-116 Hose Clamps 4
6 16-156 90° Hose Barb 3
7 18-391 Reducer Coupling 1
8 16-972 Elbow 1
9 8897-80 Hose to Tee by Valve 1
10 8897-41 Hose to fitting on Back of Tank 1
11 16-159 Tank Fitting 1
12 17-635 Mount Bracket PART OF BOOM 1
1. Make sure all chemicals have been flushed out of spray system, as you will be disconnecting fittings
from the pump. Remember to use threaded tape on all new fitting connections.
2. Remove the 1
1
/
4
" plug from the tee on the outlet side of the pump and install one Hose barb (16-156).
Then tighten so it points to the left side of the machine.
3. Install mounting brackets onto left side of center boom between boom pivot and vertical boom support.
Secure with
3
/
8
x 3 bolt, flat washer (top and bottom) and lock nut.
4. Bolt Clean-load assembly onto mounting bracket using four flange bolts
5
/
16
-18 x
3
/
4
and flange nuts.
Install 90° hose barb (16-156) into inlet side of Clean-load (valve with yellow handle) then tighten so it
points forward and down.
5. Install one reducer coupling (18-391) and one 90° Hose Barb (16-156) onto the outlet side of Clean-
load. Tighten so hose barb points forward and up.
6. Remove plug from top rear center of spray tank and discard. Install one hose barb (16-159) into tank
fitting and tighten.
7. Route 80" hose from the 90° hose barb on spray pump to the inlet side of the Clean-load and secure
with hose clamps (18-116).
8. Route 41" hose form 90° hose barb on outlet side on Clean-load to the hose barb on the top rear of the
tank.
9. Make sure all hardware, fittings, and clamps are tight. Add about 25 gallons of water to the spray tank.
Start Sprayer and circulate water through system and check for leaks.
10. Be sure to read start up and shutdown instructions for Clean-load assembly before using it with chemi -
cals. When working with chemicals always wear protective clothing, goggles and gloves.