Smithco 78-200-B, Operator'S Manual

Page: 10 / 22

8
Introduction
SETUP - BALL COUPLER AND CLEVIS HITCH
1. Install tongue (B) to main frame as explained on previous page.
2. Install adjustment slide (D) to tongue (B) using the four flange bolts
1
/
4
- 20 x
3
/
4
and four flange whiz lock
nuts
1
/
4
- 20.
3. Loosen adjustment locks (E) on control panel adjustment (F) and put control panel adjustment (F) onto
the adjustment slide (D).
4. Tighten one adjustment lock (E).
5. Slide the control panel mount (G) through the control panel adjustment (F) and tighten the other adjust-
ment lock (E).
6. The control panel (M) has all the hoses, wiring and throttle cable connected to it and to the sweeper. The
control panel is wrapped and fastened to the front of the sweeper.
7. Remove the control panel from the sweeper, bring it forward with the hoses to the rear and the throttle on
the left hand side.
8. Fasten the control panel to the control panel mount (G) with the four truss head machine screws 1 /
4
- 20 x
3 /
4
(N) and four flange whiz lock nuts 1 /
4
- 20.
9. Put the two handles (O) onto the valve and tighten the lock nuts with the handles pointing forward.
10. Place three hoses and the throttle cable on the left hand side of the adjustment slide (D).