9
Introduction
SETUP - 5
th
WHEEL HITCH
1. Install the gooseneck (tongue) (L) to main frame as explained on previous page.
2. Install the control panel mount (H) on the front of the gooseneck (L) as shown, using two
3
/
8
- 16 x 2
1
/
4
bolts (I). On the bottom bolt use lock nut (J) and just tighten snug. On the top bolt use the
3
/
8
washer and
wing nut (K). Tighten both after adjusting for the proper position.
3. The control panel (M) has all hose, wiring and throttle cable connected to it and the sweeper. The control
panel is wrapped and fastened to the front of the sweeper.
4. Remove the control panel from the sweeper, bring it forward with the hoses to the rear and the throttle on
the left hand side.
5. Fasten the control panel to the control panel mount (H) with the four truss head machine screws
1
/
4
- 20 x
3
/
4
(N) and four flange whiz lock nuts
1
/
4
- 20.
6. Put the two handles (O) onto the valve and tighten the lock nuts with the handles pointing forward.
7. Lay the hoses, wiring and throttle cable on top of the gooseneck and place the hose hold-down (P) over
the top. At the rear most hole on top of the gooseneck (L) fasten the hose hold-down with
5
/
16
-18 x 1
1
/
2
bolt and lock nut.
8. To connect to tow vehicle, remove the
1
/
2
x 3 clevis pin (R) and
1
/
8
bridge pin (S). Place gooseneck over ball
on 5
th
wheel hitch and then replace clevis pin and bridge pin.
Summary of Contents for 78-200-B
Page 16: ...14 Diagrams WIRINGDRAWING...
Page 18: ...16 Diagrams HYDRAULICDRAWING...
