37
38
smithandnoble.com
800.248.8888
HANG STRIP - INSTALLING LIGHT BLOCKS
HANG STRIP - INSTALLING HANGING STRIP INSERTS
Pre-drilling is recommended to avoid
splitting of the light block.
After adjustment, hold light
block in place, open panel and
secure the center of the light
block between the magnet
catch plates.
Adjust light block back or
forward to bring panel flush
with wall plain.
Installing Hanging Strip Inserts
After adjustments are made, close
your panels and check the gaps
between the panels and around the
window opening. Once the panels
are operating properly and gaps are
evenly distributed, carefully/firmly
press hanging strip inserts into right
and left of the frames.
NOTE: Inserts MUST be installed
prior to installing the top and bottom
light blocks.
Installing Light Blocks
After securing your inserts, position
the bottom light block flush with the
front of your hang strip. Nail/screw
(pre-drill) 1” away from the edge of
hang strip and secure light block.
Installing Light Blocks (cont)
With the left and right end of the
light block secured, close your left
panel and adjust the CENTER of the
light block as needed so that the
panel lines up with wall plain. With
panel aligned with wall plain, hold
light block in position and nail/screw
(pre-drill).
NOTE: We will not provide a top
light block for Café shutter.
Repeat above for the top light block.
Fill nail/screw hole with putty stick
if necessary.
Repeat insert installation for right hang strip.
Using Nail
Gun
After
Before
Using
Screws
Using
Screws
