31
32
smithandnoble.com
800.248.8888
HANG STRIP - GETTING STARTED
Tools & Parts
First, make sure you have all the parts and tools required to install your shutters.
HARDWARE YOU’LL NEED:
Pencil, ¼" nut driver, level, and a drill with a
1
⁄
16
" drill bit.
RECOMMENDED TOOLS:
Drill (Cordless), Tape Measure, Box knife, #2 Phillips drill tip, #6 Countersink drill bit (for
light block) if nails will not be used.
Make sure “Item #” box label matches with panels box. Each window will have 1 box of
shutters. Hang strips and light blocks will be in the same box.
• Do not dispose of packaging until the shutters are operating appropriately.
• Use of a moving blanket or drop cloth is recommended to place in front of the window
for floor protection.
• Find ample working space to assemble your frame (preferably in front of the window).
• Check the diagram to make sure you have all the parts indicated for the appropriate type
of installation.
HINGE SCREW
LIGHT BLOCK SCREW
HINGE PIN
FRAME SCREW
HINGE SPACER
HANG STRIP - ASSEMBLE FRAMES
CAREFULLY lift up on the
screwdriver to separate
frame from filler strip.
Incert screwdriver into
slot under filler strip.
Position left Hang
Strip
Slide finger along frame
to safely release the
inter strip.
Assemble Frames
Carefully remove panels and frames
from the packaging. Do not mix panels
from other windows.
All components of the frame will be
labeled: Left and Right.
Remove filler strips from the frame.
Place the filler strips away from the
work area.
Make sure fillers stay
with their frame and window.
Installing the Left Hang Strip
Place left hanging strip along the
inside left window jam of the
window.
Tip: For flush panel installation, line the backside
of hinge barrel with the wall surface.
