27
28
smithandnoble.com
800.248.8888
DIRECT MOUNT - MOUNTING HINGES
DIRECT MOUNT - MOUNTING HINGES
Slide panel to left window jam.
Panel in the window opening.
Remove the hinge pin to separate
the hinge and place onto window
jam in reference to the mark made
on Marking the Hinge Position.
NOTE: counter sink portion of hinge.
Tip: For flush mount panel: line the back of the
hinge barrel with the moulding/wall surface.
Once your top hinge is properly
positioned, install screws provided
into the center of the top and bottom
slotted hinge holes.
Note: Center set screw will be
installed in later steps.
Installing the Right Panels
Tip: Pre-drilling is recommended for proper setting
of screws. #6 countersink drill bit works best.
Place the right shutter panel into the
opening and slide into the loose-leaf
hinge that is now attached to the
wall and insert hinge pin into the
hinge.
With the top hinge pin secured,
carefully open the panel and line-up
the hinge in reference to the top
hinge. Once aligned, install screws
into the center of the top and bottom
slotted hinge holes.
NOTE: Center set screw will be
installed in later steps.
Tip: Pre-drilling is recommended for proper setting
of screws. #6 countersink drill bit works best.
Slotted hinge holes
NOTE: If the panel has more than
2 hinges, go ahead and install the
screws to the rest of the hinges.
Slotted hinge holes
