16
Note
: If the existing DIN connector will
reach the solenoid valve on the new dome
assembly, it can be used. Otherwise, use
the new DIN connector supplied with kit.
If the new DIN connector cable
(Item 9)
is used, connect the black wire of the DIN
connector cable
(Item 9)
to neutral
(see
Photo 44)
and connect the white wire to
ground
(see Photo 45)
.
Use a screwdriver to disconnect the DIN
connector on the existing solenoid valve.
Connect the new or existing DIN connector
cable
(Item 9)
to the new solenoid valve
(see Photo 46
).
Wire the red wire of the DIN connector to
the other terminal of the delay timer
(Item
14)
with the other female disconnect
(Item
16)(see Photo 47)
.
16
14
Photo 47
Photo 46
9
Photo 43
NOTE: Exact location will vary
depending on your configuration.
Photo 45
Photo 44
