10
Use the cord grip nut
(item 13)
to hold the
cord grip
(item 11)
in place. Run the DIN
connector cable
(item 9)
through the cord
grip
(item 11)
or existing panel hole and
tighten the cord grip
(item 11)
to secure
the DIN connector cable
(item 9) (see
Photo 18)
.
Find the connection where the solenoid
valve is wired to the black wire of the delay
timer. Typically, this is located in the wire
troughs
(see Photo 19)
.
Connect the red wire of the DIN connector
cable
(Item 9)
to the black wire of the
existing delay timer. Connect the black
wire of the DIN connector cable
(Item 9)
to neutral
(see Photo 20)
and connect
the white wire to ground
(see Photo 21)
.
Photo 19
Wire Troughs
NOTE: Exact location will vary
depending on your configuration.
Photo 20
Photo 21
Photo 18
13
11
