Installation
18
Always use pipe-joint compound made for
use with NATURAL GAS and L.P. GAS
between pressure regulator
D
and NPT
adaptor
C
and between pressure regulator
D
and pipe
E
. If a flexible metal conductor
is used, make sure that the tubing is not
kinked.
Use only pipes (
E
) conforming to standard
regulations in force, inserting gasket
B
(supplied) between fitting
A
and adaptor
C
.
Always apply a suitable sealing substance
(such as Teflon tape) between pressure
regulator
D
and adaptor
C
and between
pressure regulator
D
and pipe
E
.
Test the appliance
Follow these instructions to leak test the
appliance:
Use a brush and liquid detergent to test all
gas connections for leaks. Bubbles around
connections indicate a leak. If a leak
appears, shut off the gas valve controls and
adjust the connections. Then check the
connections again. Remove all the
detergent product from the range. Replace
the parts on the burner and turn the knobs
on the gas tap valves.The supply line must
be fitted with an approved shut-off valve.
This valve should be located in the same
room as the range and should be in a
location where it can be easily opened and
closed.
Do not block access to the shut-off valve.
The valve is necessary for turning the gas to
the appliance on or off.
Incoming line pressure upstream from the
regulator must be 1” (2.5 cm) W.C.P. higher
than the manifold pressure in order to check
the regulator. Incoming line pressure to the
regulator should be as follows for operation
and checking the regulator setting:
WARNING
: The tightening torque
of adaptor (C ) must not be greater
than 36 ozf - 10 Nm.
