Instructions for the installer
2.2
Electrical connection
Make sure the voltage and the cross-section of the power supply line
match the specifications indicated on the identification plate positioned in
the storage compartment.
Do not remove this plate for any reason.
The plug at the end of the power cable and the wall socket must be the
same type (conforming to regulations in force). Check that the power line
is adequately grounded. Do not use reducers, adapters or shunts.
Fit the power supply line with a multipolar cut-out device with a contact
opening gap equal to or greater than
3 mm
in an easily accessible
position close to the appliance.
The connection terminals are
located at the rear of the
appliance. For electrical
connections see the following
diagram. To access, remove
the rear cover.
47