QuickServer Start-Up Guide
Page 18 of 71
5
INSTALLING THE QUICKSERVER
5.1 RS-485
5.1.1 RS-485 Connection R2 Port
Connect to the 3 pins on the left-hand-side of the 6-pin connector as shown.
The following Baud Rates are supported on the R2 Port:
4800, 9600, 19200, 38400, 57600, 115200
For connection details to RS-232 or RS-422, refer to
Appendix A.1
.
5.1.2 RS-485 Connection R1 Port
NOTE: The following only applies to non-LonWorks QuickServers with an RS-435 R1 port.
Connect to the 3-pin connector as shown.
The following Baud Rates are supported on the R1 Port:
110, 300, 600, 1200, 2400, 4800, 9600, 19200, 20833, 28800, 38400, 57600, 76800, 115200
Figure 10: RS-485 R2 Connection Port
Figure 11: RS-485 R1 Connection Port
+
-
GND
B+
A-
SG
