- 19 -
7-3. How to mount auto switch
7-3-1. D-M9
□
/D-A9
□
When mounting an auto switch, insert it into the switch groove of the cylinder from the direction shown
below. After setting in the mounting position, use a flat head watchmaker's screwdriver to
tighten the set screw.
Figure-18
Caution
(1) Auto switch mounting bracket
When tightening an auto switch mounting screw, use a watchmaker’s screwdriver with a grip diameter of 5 to 6mm.
(2) Tightening torque
・
D-A9
□(V) : 0.10 to 0.20 N
・
m
・
D-M9
□(V) : 0.05 to 0.15 N
・
m
As a guide, turn 90° from the position where it starts to feel tight.
(3) Insertion direction in installation
Auto switch can be inserted only from the head side.
7-3-2. D-P3DW
□
①
Fix the auto switch and the auto switch mounting bracket temporarily by tightening the attached hexagon
socket head cap screw (M2.5X9.5L) 1 to 2 turns.
②
Insert the temporarily tightened mounting bracket into the mating groove of the cylinder tube, and slide the
auto switch onto the cylinder tube through the groove.
③
Check the detecting position of the auto switch and fix the auto switch firmly with the hexagon socket head cap
screw (M2.5X6L, M2.5X9.5L).*
④
If the detecting position is changed, go back to step
②
.
*The hexagon socket head cap screw (M2.5X6L) is used to fix the mounting bracket to the cylinder tube.
Figure-19
Caution
・
Ensure that the auto switch is covered with the mating groove to protect the auto switch.
・
The tightening torque for the hexagon socket head cap screws (M2.5X6L, M2.5X9.5L) is 0.2 to 0.3N
・
m.
・
Tighten the hexagon socket head cap screws evenly.
Auto switch
Watchmakers screw driver
(Flat head screw driver)
Auto switch mounting screw
Auto switch mounting bracket
Hexagon socket head cap screw (Auto switch attachment)
(M2.5×9.5L)
Hexagon socket head cap screw
(M2.5×6L)
Summary of Contents for RS2H Series
Page 24: ...23...