15
In this page, you can configure the WAN interface of the device.
Click
Add
and the page as shown in the following figure appears:
The following table describes the parameters in this page.
Field
Description
ATM PVC CONFIGURATION
VPI
Virtual Path Identifier (VPI) is the virtual path between two points in an ATM network. Its
value range is from 0 to 255.
VCI
Virtual Channel Identifier (VCI) is the virtual channel between two points in an ATM
network. Its value range is from 32 to 65535 (0 to 31 is reserved for local management of
ATM traffic).
Service Category
Select
UBR with PCR
,
UBR without PCR
,
CBR
,
Non Real-time VBR
, or
Real-time VBR
from the drop-down list.
Peak Cell Rate
Set the maximum transmission rate of the cell in ATM transmission.
Sustainable Cell Rate
Set the minimum transmission rate of the cell in ATM transmission.
Maximum Burst Size
Set the maximum burst size of the cell in ATM transmission.
CONNECTION TYPE
Protocol
Select
PPP over ATM (PPPoA)
,
PPP over Ethernet (PPPoE)
,
MAC Encryption Routing
(MER)
,
IP over ATM (IPoA)
, or
Bridging
from the drop-down list.
