SMC Networks 2552W-G2, User Manual

Page: 165 / 294

System Logging Commands
6-27
6
show hardware
This command displays the hardware version of the system.
Command Mode
Exec
Example
System Logging Commands
These commands are used to configure system logging on the access point.
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
DHCP Relay : DISABLED
==============================================================
Version Information
=========================================
Version: v4.3.2.2
Date : Dec 20 2005, 18:38:12
=========================================
Enterprise AP#
Enterprise AP#show hardware
Hardware Version Information
===========================================
Hardware version R01
===========================================
Enterprise AP#
Table 6-6. System Logging Commands
Command Function Mode Page
logging on Controls logging of error messages GC 6-28
logging host Adds a syslog server host IP address that will receive
logging messages
GC 6-28
logging console Initiates logging of error messages to the console GC 6-29
logging level Defines the minimum severity level for event logging GC 6-29
logging facility-type Sets the facility type for remote logging of syslog
messages
GC 6-30
logging clear Clears all log entries in access point memory GC 6-31
show logging Displays the state of logging Exec 6-31
show event-log Displays all log entries in access point memory Exec 6-32